Resize Worn or Mis-Machined Bearing & Seal Areas

Restore rather than Replace

Damage from wear, corrosion, or mis-machining can be repaired using Electro-Chemical Metallizing. Deposits that offer wear resistance, low electrical contact resistance, or corrosion protection also can be applied selectively to improve components that have been manufactured from inexpensive base metals.

Electro-Chemical Metallizing Process equipment is portable, enabling the operator to meet metallizing and build-up requirements wherever they arise. This flexibility is an important cost and time saver. It minimizes dismantling, downtime, turnaround delays, and shipping charges usually associated with sending parts out to be metallized.

The Cost Effective Solution

APPLICATION

  Salvage mis-machined parts

  Refurbish worn parts such as journals, gears, bearings, oversized ID's and undersized OD's

  Reduce RFI / EMI emissions

  Lower electrical contact resistance

  Seal porous cast surfaces

  Protect bearing surfaces from fretting

  Touch up damaged plating

  Repair hydraulic cylinders and pistons

  Provide corrosion protection

  Under-sized

  Over-sized

  False cuts

ADVANTAGES

  Prompt, effective on-site metallizing at minimal total cost

  Pinpoint plating w/o extensive masking or special fixtures

  Metallizing done to size w/ little or not final machining

  Portable equipment that provides immediate in-house capability

MEETS MILITARY STANDARDS > APPROVED AS PERMANENT REPAIR

  Meets numerous Federal, Military and Commercial Specifications

  Military Standards > Brush Plating (MIL-STD-865)

  Military Standards > Repairing (MIL-STD-2197)

  Hardness Rockwell Industry Standards (54 HRc)

  Approved by American Railroad Association

  Federal Government Specifications (Electro-deposited Nickel Plating QQ-N-290)

EXAMPLES OF PARTS THAT CAN BE REPAIRED w/ ARROW ELECTRO-PLATING

The Wave of the Future

x